How to Replace a Step2 Play Kitchen Oven Light Module

By Kids Toys, Playhouses, Wagons & Outdoor Products | Published: 2026-10-29

Category: How-to Guides

Learn how to replace a Step2 play kitchen oven light module when the LED stops working. Follow these simple steps to restore the glow.

Quick answer

To replace a Step2 play kitchen oven light module, you'll need a compatible replacement part like the Oven Led Light Module (181876). Follow the steps below to swap it out safely.

Why the oven light might stop working

The LED light in a Step2 play kitchen can stop working for a few reasons: worn-out wiring, a loose connection, or simply a failed LED module. Because the module is a sealed LED unit, you can't just swap in a standard bulb—you need the correct replacement part.

Before you order, confirm your oven model and the original part number. The Oven Led Light Module (181876) is a genuine Step2 replacement part for select oven models, so double-check compatibility to avoid a mismatch.

Tools and preparation

You'll need a Phillips-head screwdriver and a small flat-head screwdriver or plastic pry tool. Work on a flat surface with good lighting, and keep the screws in a small container so they don't get lost.

Unplug the play kitchen if it's battery-powered, and remove any batteries to avoid accidental activation during the repair.

Step-by-step replacement steps

Remove the oven door: Open the oven door and locate the hinge pins on both sides. Use a flat-head screwdriver to gently pry the pins out, then lift the door off and set it aside. Common mistake: forcing the door can crack the hinges, so go slowly.
Access the light module: Look inside the oven cavity for the light module housing. It's usually secured by one or two screws. Remove them with a Phillips-head screwdriver and pull the housing forward to expose the module. Checkpoint: if the housing doesn't budge, check for hidden screws or clips.
Disconnect the old module: Unplug the wire connector from the back of the module. If it's stuck, rock it gently side to side—don't yank. Common mistake: pulling the wires themselves can damage the harness, so always grip the connector.
Install the new module: Connect the wire connector to the new Oven LED Light Module (181876). Make sure it clicks into place. Then reattach the housing and secure it with the screws you removed earlier. Checkpoint: verify the connector is fully seated before reassembly.
Test the light: Reinsert batteries or plug in the play kitchen, then turn on the oven light. If it doesn't light up, double-check the connector and ensure the module is compatible with your model. Common mistake: skipping this test and reassembling everything only to find the light still doesn't work. If the light still doesn't work, the issue may be the wiring harness or the main board—contact Step2 support for further help.

Product facts

Oven Led Light Module (181876): This Oven LED Light Module (model 181876) is a genuine Step2 replacement part for select oven models. Using a genuine part ensures proper fit and reliable performance, so you don't have to worry about compatibility issues.
Oven Led Light Module (181876)